Security alarms are placed to ensure that the home security is tight. The sound of the alarm is set to notify the homeowner and even the surrounding neighbors. A continuous alarm siren can be so annoying and is even at times enough to make one crazy. There are many reasons that can cause an alarm to go off. One of the reasons could be a power outage, Low batteries or defective wiring could also be another reason. To disable your alarm system at home, you can identify the cause of it with the help of the steps listed below.
1. Using the Switch on/off button to disable the alarm
In case that there is an alarm sound, first of all, one needs to check whether there is an incidence. Since the main objective of the security alarm is to detect security alerts, it is wise to first check for security concerns. Mostly, it could be because of a fire, stranger intrusion or even a carbon monoxide leak. In case of an incidence, disable the alarm using the switch on/off button and then find yourself place to wait for the authority to respond.
2. Disable the alarm by replacing the batteries
Secondly, one needs to check the alarm batteries. In many cases, the alarm beeping may be due to low batteries. Therefore replacing the alarm batteries would work towards disabling the alarm sound. One is required to move around the house testing batteries related to the security system. Additionally, it is important to ensure that the right batteries are used in the replacement as faulty ones will not stop the alarm sound.
Before unplugging the panel’s transformer, it is advised that you disconnect the backup battery to prevent electrical issues. The type of panel will often determine where the battery is placed. The backup battery is often hidden beneath the panel’s rear cover for wireless systems. The circuit board of the panel will receive it. To detach the battery, just unplug the connection.
3. Alarm reset button
The third way to disable an alarm is to enter your code. This feature is seen in all security alarms. However other alarms have a reset button available on the back side of the panel. In the case the two options are not available, there is also another method where one can arm the alarm system and instantly disarm. Additionally, one can press the status button available on the keypad.
4. Faulty wiring system
Checking for defective wiring is another way if the above-mentioned steps do not work. In most cases, the alarm system wiring might be corroded hence triggering the alarm. It is advisable to use a voltmeter when performing the check. This exercise should be done if one has electrical experience. Otherwise, it is advised to contact or hire an electrician for help.
Additionally, it is wiser to hire an expert to complete the work because they are more knowledgeable than you are about it.
5. Contact the Alarm Provider
After trying all the mentioned ways with no success, the last step is to contact the alarm provider. The providers are required to assist you through troubleshooting through the phone or sending a technician to your house. That said, it is notable that security system alarms beep as a way of alerting you of defective batteries, wires that are corroded or danger.
Latest Posts
- 3 Ways to know your Alarm System is Outdated
- Vivint vs ADT
- 7 Best Outdoor Motion Sensor Lights for Homes
- Top Home Security Systems in Atlanta, GA
- How to Cancel Your Alarm Contract
Growing up with Law and Order and CSI shows taught Isabelle Landau one thing: if people back then had high-quality home security systems, those series would have been way shorter. In our modern world, technology helps us keep burglars away easily, and this is what Izzy studies and writes about: alarm systems, home security, protection systems, and more.
Leave a Reply